Over-the-Air TV Antennas
Sensar & Rayzar Air Antennas
11
Sensar & Rayzar Air Antennas
Rayzar Air Retrofit Kit
e Rayzar Air retrot kit has been designed to replace an existing antenna
that uses Winegard's standard lift assembly/mounting bracket. is includes
the Rayzar Air and Sensar line of antennas. e Rayzar Air retrot kit
includes a 16″ boom, but the replacement head can be installed using the
included boom or using the existing boom from the existing installation. A
summary of each installation option is below.
Replacing an Existing Antenna using the Included Boom
is is the recommended installation. In this installation, the Rayzar Air
replacement head is attached to the included 16" boom with two supplied
bolts. en, the coax cable is disconnected from the existing antenna, and the
e-clips and pins from the existing lift arms are removed, before removing the
existing lift arms. If replacing a Sensar antenna, the coax cable must be pulled
through the elevation tube and will require the connector to be cut o to do
so. e elevation gear from the existing antenna is then inserted into the end
of the Rayzar Air replacement antenna. e Rayzar Air replacement assembly
is connected to the lift assembly via pin and e-clip, and the replacement is
complete once the coax cable has been t with a connector and reconnected
to the F-jack on the Rayzar Air antenna head.
Replacing an Existing Antenna using the Existing Boom:
Securing Antenna Head with Two Bolts
First, raise the antenna, and remove the pins and e-clips that connect the
existing antenna head to the booms. en, identify the boom that does not
have coax cable running through it, and remove the pin and e-clip to remove
the boom. Place the Rayzar Air antenna head assembly on the remaining
boom, and insert a bolt through the aligned holes in the antenna head
assembly and boom. Use a drill with a 9/32″ bit to drill through the second
set of holes in the Rayzar Air antenna head assembly and through the boom.
Insert a bolt through the drilled hole, and connect the coax cable to the
F-jack on the antenna head.
Replacing an Existing Antenna using the Existing Boom:
Securing Antenna Head with One Bolt
To replace an existing antenna with the Rayzar Air antenna head, raise the
antenna, and remove the pins and e-clips that connect the existing antenna
head to the booms. en, identify the boom that does not have coax cable
running through it, and remove the pin and e-clip to remove the boom. Place
the Rayzar Air antenna head assembly on the remaining boom, and insert
a bolt through the aligned holes in the antenna head assembly and boom.
Connect the coax cable to the F-jack on the antenna head.
Consult the Rayzar Air retrofit kit
manual for specific instructions on
replacing an existing antenna with the
Rayzar Air antenna.
FIGURE 4.16. Rayzar Air Retrofit Kit
(24 pages)
(8 pages)
(86 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals