Winegard RVRZ25B Owner's Manual download pdf (Page 10)

Over-the-Air TV Antennas

Sensar & Rayzar Air Antennas

Wiring the Antenna, Cont.

Complete the following steps to wire the power supply (see g. 4.12):

Front of Power Supply

Step 6

Step 7

Step 5

Back of Power Supply

Step 1

Step 2

Step 3

Step 4

FIGURE 4.12. Power supply included with Sensar, Rayzar Air, and RoadStar antennas

1. Make 12 V connection to the power supply. Install terminals on wires

from +12 VDC source, and crimp the terminals with an appropriate

crimping tool.

2. Connect the coax cable from the antenna to the “ANTENNA” port on

the power supply, and tighten until ngertight.

3. If hooking up the antenna to a second television, connect a coax cable

from the “SET 2” port on the back of the power supply to the “Antenna In”

port on the second television.

4. If hooking up a cable input, connect the cable from the cable input to the

“CABLE” port on the back of the power supply (see fig. 4.13).

5. Mount the power supply with the provided screws.

6. Connect a coax cable from the coax port on the front of the power supply

to the “Antenna In” coax port on the TV.

7. Press the “ON” switch on the front of the power supply, and check that

the light is on.

FIGURE 4.13. Cables wired to back of power supply

If in doubt as to the polarity of the

wires, connect the wires temporarily

to the tabs, and press the “ON” switch

on the front of the wall plate. If the light

turns on, the polarity is correct. After

checking the polarity, turn the power off.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 19 20

No comments

Winegard RVRZ25B Owner's Manual Page 10