Congratulations!
You have selected the Winegard
®
TRAV’LER Automatic Multi-Satellite TV Antenna. The TRAV’LER
antenna will deliver the ability to view up to ve satellites at the same time with unmatched signal
strength, the lowest travel height on the market, maximum HD capabilities and easy to use functionality
– just like you get at home. This manual provides important information on the installation and operation
of your TRAV’LER Interface Box. Please take time to read the manual in it’s entirety before installing or
operating your antenna.
Recommended Receivers:
The Winegard
®
TRAV’LER Automatic Multi-Satellite TV Antenna will work with any DIRECTV
®
receiver currently in production. Consult your receiver manual or www.winegard.com if you have any
questions about whether your receiver is compatible. However, we recommend:
DIRECTV : models D11 and H20
Each receiver will require at least one coax cable. Refer to receiver manual for wiring details.
Check with your programming provider for coverage in certain areas.
Before you begin, please make sure you have received all necessary parts to properly install and oper-
ate your TRAV’LER antenna.
- Installation/Operation Manual
- Mount Base with 30’ Cable - Power/Control Cable
- TRAV’LER Interface Box
- Reector, LNBF & Feed Arm
- 24” AC power cord
- TRAV’LER Power supply
- Gray Coax Cable 30’
- Black Coax Cable 30’
- Mounting Hardware bag
- Cable Entry Hardware bag
Selecting a Location for the TRAV’LER Antenna
Before removing the TRAV’LER antenna from its box, check with your RV Dealer or manufacturer. Your
RV may be pre-wired or have a reinforced area for this system. DO NOT install in a location where a
gap of 3/16” or more exists, as it may damage the roof. See diagram at top of page 3.
2
Icons appearing in the manual are used for important information and helpful tips.
Alert indicates important information regarding
product use, product specications or procedures.
Important tip offers helpful suggestions or
refers you to a related topic in the manual.
INSTALLATION
When installing the TRAV’LER on a rubber roof, Winegard recommends using the SKA-004 Roller
Plate. If not using this plate, make sure that the roller does not come in contact with any rib supports
or bubbles in the roof when in operation. Failure to do so, may result in damage to the roof.
(24 pages)
(8 pages)
(86 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals