Winegard SK-3003 User Manual download pdf (Page 9)

The coaxial connection ports are located on the base of the LNB. To connect a coaxial cable to

each port, it may be necessary to remove the roller in front of the coaxial connection ports.

Complete the following steps to remove the roller and access the coaxial connection ports:

Locate the pin that holds the roller to the feed arm.

Using a 7/16” wrench, remove the nut from the pin.

Remove the pin from the roller, and remove the roller.

Connect a coaxial cable to each coaxial connection port.

Align the holes in the roller with the holes in the feed arm.

Place the pin through the holes in the feed arm and in the roller.

Thread a nut onto the pin, and tighten.

In some installations, a clamp may be used to hold down cables on the roof of the RV. If using a clamp, install the

SWM8 after the first clamp.

Roller

Base of LNB

Connecting Coaxial Cables to Crank-up Antennas

www.winegard.com/mobile

For Technical Services, email [email protected] or call 1-800-788-4417

For Receivers and Programming, call 1-866-609-9374

For up-to-date information on receiver compatibility and programming,

visit www.winegard.com/receivers

WinegardCompany•3000KirkwoodSt.•Burlington,IA52601-2000

800/788-4417•FAX319/754-0787•www.winegard.com•PrintedinU.S.A.

Winegard, TRAV’LER, Carryout, RoadTrip, Mission, and DuraSAT are registered trademarks of Winegard Company, and MiniMax, Anser, and MP1

are trademarks of Winegard Company. DIRECTV is a registered trademark of DIRECTV, Inc., a unit of Hughes Electronics Corp.

Disclaimer: although every effort has been made to ensure that the information in this manual is correct and complete, no company shall be held

liable for any errors or omissions in this manual. Changes and technological advances are continuously being made in the satellite antenna market.

Information provided in this manual was accurate at time of printing.

1 2 3 4 5 6 7 8 9

No comments

Winegard SK-3003 User Manual Page 9