Winegard RoadTrip SD Installation Manual download pdf (Page 2)

1. Open box and remove packing material.

2. Lift dome out of box vertically. Then lift unit out of

box vertically. Do not turn box and “roll” out, or turn

upside down to remove.

4’ Gray Coax Cable (OEM Model)

4’ White Coax Cable (OEM Model)

4’ Power Cable (OEM Model)

Parts Included • Tools Needed • How to Unpack

If using knife to open

carton, BE CAREFUL.

Do not cut the dome on

the unit.

1 Radome

1 Cable entry plate

All required screws, washers, bolts, and nylocks

1 base with electronics, dish, dual LNBF,

mounting feet

LIFT UNIT STRAIGHT UP

OUT OF CARTON!

UNPACKING THE UNIT

PARTS INCLUDED:



The Winegard RoadTrip is designed specifically for use with motorized recreational

vehicles. Winegard recommends using a qualified installer familiar with RV structure and

wiring to ensure proper installation and to prevent damage to RV or dish.

REV. 12/05

USE 2 PEOPLE

when removing the unit

from the carton.

DO NOT PAINT DOME!

Painting dome will

cause signal

degradation and will

void your warranty.

TOOLS NEEDED FOR UNPACKING & INSTALLATION:

Level

Drill w/3/4” bit

1-1/4” hole saw (if mounting switch in wall)

Phillips screw driver #2

3/8” Open end wrench

7/16” Open end wrench

Sealant (consult RV manufacturer for proper type

for your roof material)

1 2 3 4 5 6 7 8

Comments to this Manuals

No comments

Winegard RoadTrip SD Installation Manual Page 2

Comments to this Manuals

Related products and manuals for Television antennas Winegard RoadTrip SD