Winegard MV3500A Owner's Manual download pdf (Page 5)

All required screws, washers, bolts, and nylocks

1 base with electronics, dish, dual LNBF

30’ Coax Cable

30’ Power/Data Cable bundle

1. Open box and remove packing material.

2. Lift dome out of box vertically. Then lift unit out of box

vertically. Do not turn box and “roll” out, or turn up-

side down to remove.

USE 2 PEOPLE

when removing the unit

from the carton.

Parts Included • Tools Needed • How to Unpack

If using knife to open

carton, BE CAREFUL.

Do not cut the dome on

the unit.

1 Radome

1 Power switch

1 Wall plate (white)

1 Surface mount box

1 Cable entry plate

4 Base feet

large yellow ag connector

2 small red ag connectors

LIFT UNIT STRAIGHT UP

OUT OF CARTON!

TOOLS NEEDED FOR UNPACKING & INSTALLATION:

UNPACKING THE UNIT

Level

Drill w/3/4” bit

1-1/4” hole saw (if mounting switch in wall)

Phillips screw driver #2

3/8” Open end wrench

1/2” Drill bit

7/16” Open end wrench

Sealant (consult RV manufacturer for proper type

for your roof material)

PARTS INCLUDED:

BE CAREFUL when

removing unit. Dome is

attached to base by only

3 pieces of tape, NOT BY

SCREWS.

DO NOT PAINT DOME!

Painting dome will cause

signal degradation.

REV. 7/07

1 2 3 4 5 6 7 8 9 10 11 12

Comments to this Manuals

No comments

Winegard MV3500A Owner's Manual Page 5

Comments to this Manuals

Related products and manuals for Television antennas Winegard MV3500A