Winegard RVRZ25B User's Guide download pdf (Page 6)

Winegard Rayzar Air Antenna

Installing the Crank Assembly

Slide the ceiling plate over the top of the directional

handle with the pointers aligned.

TIP: The knobs on the directional handle should fit into

the grooves on the ceiling plate.

Slide the ceiling plate and directional handle assembly

over the elevating shaft.

Drill pilot holes in the ceiling. Then, mount the ceiling

plate with the four provided ceiling plate screws.

Remove the backing from the decal, and place the

decal on the bottom of the directional handle.

Slide the spring over the elevating shaft.

Set the nylon bearing over the top of the crank handle.

Slide the crank handle onto the elevating shaft.

Check that the set screw aligns with one of the flat

sides of the elevating shaft.

Tighten the set screw until it touches the elevating

shaft, and then tighten only ¼ turn more. Note that the

set screw simply holds the crank handle to the

elevating shaft.

Installing the Power Supply

The power supply may be flush mounted in most

standard electrical boxes. To flush mount, cut a hole in

the wall to fit the box. Run two #12 wires between the

wall plate and +12 VDC source, and route downlead

cable to this location.

Before connecting any cables or wires, make sure the

power supply is turned off. Then, select a location for

the power supply.

Make 12 volt connection to the power supply. Install

terminals on wires from +12 VDC source, and crimp

the terminals with an appropriate crimping tool. If in

doubt as to the polarity of the wires, connect them

temporarily to the tabs, and press the power button

on the front of the wall plate; if the light comes on, the

polarity is correct. Turn the power off.

Connect the coax cable from the antenna to the

“ANTENNA” port on the power supply, and tighten

until fingertight. (The coax cable should have been

routed through the ceiling and wall to the chosen

wall plate location.) If the connector is removed

before routing the coax cable, see the next page for

instructions on re-installing the connector.

If connecting the antenna to a second television, connect

a coax cable from the “SET 2” port on the back of the

power supply to the “Antenna In” port on the television.

Page 5

1 2 3 4 5 6 7 8 9 10 11 ... 23 24

Comments to this Manuals

No comments

Winegard RVRZ25B User's Guide Page 6

Comments to this Manuals

Related products and manuals for Television antennas Winegard RVRZ25B