Winegard Rayzar Air Replacement Antenna Head
Align the holes in the remaining boom and the boom
adapter on the Rayzar Air antenna head. Make sure the
boom is fully inserted into the boom adapter. Note that
the “W” logo should face upwards in the stowed position.
Place a washer on a ¼” x 20 bolt, and insert a ¼” x 20
bolt through the visible aligned holes in the boom and
boom adapter.
Place a washer on the end of the ¼” x 20 bolt, and
thread a nut on the bolt.
Ensure the boom is flush with the head.
Use a drill with a 9/32” bit to drill through each side of
the boom. To ensure that the holes align, it is
recommended to individually drill each hole.
Once the holes have been drilled, place a washer on
the other ¼” x 20 bolt, and insert the bolt through the
drilled holes in the boom and boom adapter.
Place a washer on the end of the ¼” x 20 bolt, and
thread a nut on the bolt.
Tighten each nut until the boom adapter touches the
boom on both sides, securing the head.
WARNING: Do not overtighten bolts.
Make sure the weather boot is in place over the boot
collar of the mounting bracket.
Re-connect the coax cable to the antenna head; hand-
tighten, and tighten a quarter turn more with a wrench.
Option 2: Securing Antenna Head to
Existing Boom with One Bolt
Before proceeding, make sure that the power supply is
turned off and the antenna is in the deployed position.
On the existing antenna, disconnect the coax cable
from the antenna head.
Remove the pins and e-clips securing the antenna head
to the existing booms, and remove the antenna head.
Identify the boom that does not have the coax cable
running through it.
Remove the e-clip and pin from the identified boom,
and remove the boom. This boom is not required for
operation of the Rayzar Air antenna.
Align the holes in the remaining boom and the boom
adapter on the Rayzar Air antenna head. Make sure the
boom is fully inserted into the boom adapter.
Place a washer on a ¼” x 20 bolt, and insert the bolt
through the aligned holes in the boom and boom adapter.
Place a washer on the end of the ¼” x 20 bolt, and
thread a nut onto the bolt. Tighten the nut until the
boom adapter touches the boom on both sides.
WARNING: Do not overtighten bolts.
Drill hole
side of boom
Boom
Weather Boot
over Boot Collar
Mounting Bracket (overhead view)
Gear Housing
8.
9.
11.
1.
2.
3.
4.
5.
Page 3
10.
12.
13.
14.
6.
7.
8.
15.
7.
6.
! !
(12 pages)
(8 pages)
(86 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals