Winegard RM-00DE Owner's Manual download pdf (Page 2)

INSTALLATION & ASSEMBLY

STEP 1. Choose a location on the roof for dish that will allow dish to raise and rotate without

interfering with other roof-mounted equipment. Make sure inside ceiling plate is easily

accessible, and with no obstructions that would interfere with operation.

Figure 1 shows minimum distance (10") antenna should be located from edge

of vehicle roof. It is recommended that you check with your dealer or manufacturer

for provisions that may have been made in the roof for antenna mounting; a

reinforced roof area, or pre-wire installation

from the factory.

NOTE:

The system must be level for

proper operation

. Winegard Model

RW-5000 roof wedge with gasket is available. If

inside roof wedge is needed, Winegard’s

RW-1000 can be trimmed to fit ceiling plate.

STEP 2. Position template on roof (pg. 8 this

manual). CAUTION: DO NOT drill through wiring.

Carefully drill a 1-3/4"hole through roof and ceiling

of vehicle. Inspect hole to make sure wiring is

intact. (Roof template, pgs. 8-9.)

1 2 3 4 5 6 7 ... 15 16

No comments

Winegard RM-00DE Owner's Manual Page 2