Winegard AS-2053 Installation Manual download pdf (Page 6)

System Operation

BEFORE parking and leveling vehicle, look for trees,

buildings, hills or mountains that might block the satellite

signal and result in poor signal reception.

ABOUT YOUR RECEIVER (The unit is factory preset

to find 119°W (DISH Network):

If you have a DISH Network

receiver, be sure your unit

(AS-2003) is set to receive DISH Network satellites. If

you have a DIRECTV

receiver, be sure your unit

(AS-2003) is set to receive DIRECTV satellites. (The

majority of programming for DISH Network is on satellite

119°W; for DIRECTV, it is on 101°W.)

AS-2003 is factory preset to find 119°W (DISH

Network). You can contact DISH Network at 1-800-333-

DISH (1-800-333-3474) for programming information.

Contact DIRECTV at 1-800-DIRECTV (1-800-347-3288),

or ExpressVu (Canada and Northeast U.S.) at

1-888-SKY-DISH (1-888-759-3474).

IMPORTANT! If you are using more than one receiver,

the primary (the “bright white” coax connection) is the

only receiver that will toggle between satellites.

Wall Plate Control Panel

LED ERROR CODES

Errors are indicated by LEDs.

OFF AND SEARCH LEDs are on.

Satellite signal search failure.

ON, PARK, SEARCH, OFF LEDs are on.

Indicates receiver is not plugged into

active 110 VAC, malfunction of receiver,

bad LNBF or bad coax connection.

ON, OFF LEDs are on.

Indicates a problem with the unit motor.

POWER MUST BE TURNED OFF AND

BACK ON TO CLEAR ERROR LIGHTS.

FIRST TIME USE:

The unit is factory preset to find 119°W (DISH Net-

work). For DIRECTV, you must change the preset

switches on the outside unit. See Step 8 in Installation,

page 14.The first time your unit is used, allow 10 minutes

for GPS acquisition. (This is also true if you have stored

your unit for six months or longer. This is typical of first

time use; do not think there is a malfunction.

1. Turn TV on and tune to channel 3 or 4 (the output

of your receiver).

2. Turn on your primary receiver. The receiver MUST

BE TURNED ON and LNBF COAX PROPERLY

ATTACHED (refer to your receiver owner manual). If

not properly connected, all LEDs will be on.

3. To search for satellite, see Power On and Satellite

Search procedures, AS-2003 Control Panel

Operation instructions, page 7.

4. After search routine is completed and primary

receiver is at 119 (DISH Network), the unit may

switch between the primary and alternate satellite. A

Check Switch must be performed for toggling

capabilities on DISH Network. See Check Switch

instructions, page 8.

5. After the primary satellite signal is found and Check

Switch completed, the unit may be powered off. To

switch satellites, turn power back on and switch

satellites. The unit can then be turned off. The satel

lite signal last selected will still be “seen” by the dish

when the unit is turned on again.

6. To park your unit, see Parking procedures, AS-2003

Control Panel Operation instructions, on page 7.

OFF

SEARCH/

MOVING

PARK

WINEGARD

AS-2003

SATELLITE SYSTEM

1 2 3 4 5 6 7 8 9 10 11 ... 23 24

Comments to this Manuals

No comments

Winegard AS-2053 Installation Manual Page 6

Comments to this Manuals

Related products and manuals for Satellite antennas Winegard AS-2053