Winegard RP-SK95 User Manual download pdf (Page 3)

Installing the Replacement LNB Assembly

Position the reflector bracket (of the replacement LNB assembly) against

the adapter plate. Make sure the fourth outer hole in the adapter plate

is centered in the bottom slot of the reflector bracket. The third and fifth

outer holes should be close to opposite edges of the bottom slot.

Place the stiffener plate inside the reflector bracket. Make sure the

second and third outer holes in the stiffener plate are centered in the

bottom slot of the reflector bracket. The second and third outer holes

in the stiffener plate should additionally align with the third and fifth

outer holes in the adapter plate.

Install bolts through the four outer holes in the stiffener plate, and tighten.

Connect the coaxial cable from the LNB assembly to port C of the turret.

Align the hole in the p-clamp with the hole in the lift arm, and make

sure the hole in the p-clamp is positioned above the cable. Install the

screw through the p-clamp and lift arm, and tighten.

Install the reflector bolts through the four corresponding holes in the

reflector and reflector bracket. Install the reflector nuts, and tighten.

Stowing the Antenna

Plug in the interface box.

Press and hold “POWER” for two seconds to turn on the interface box.

Then, press the Power button again to stow the antenna.

Winegard Company • 3000 Kirkwood St. • Burlington, IA 52601-2000

1-800/788-4417 • FAX 319/754-0787 • www.winegard.com

Winegard and TRAV’LER are registered trademarks of Winegard Company.

3 2

Bottom slot of the

reflector bracket

Stiffener plate

1 2 3

No comments

Winegard RP-SK95 User Manual Page 3